Red Lion, OH
This Roof Was a Coil of Steel This Morning
The roof started the day as a flat coil of steel. Our trailer roll-former shapes each standing seam panel right on site, cut to run in one piece from eave to ridge.
15 job-site videos
Most people never see what goes into a metal roof. These short videos from real jobs show it: panels roll-formed in the driveway, valleys before the metal goes on, decking checks, chimney removals and snow guards.
Red Lion, OH
The roof started the day as a flat coil of steel. Our trailer roll-former shapes each standing seam panel right on site, cut to run in one piece from eave to ridge.
Anna, OH
Forming panels in the driveway means one piece from eave to ridge with no laps across the roof, cut to the exact length of this roof, and no long panels bent in shipping.
Lena, OH
A flat sheet of steel coil goes in, each set of rollers bends it a little more, and a finished panel comes out in one pass with no seams in the middle.
Red Lion, OH
A roof valley before the panels go on. Solid sheathing and synthetic underlayment cover the deck, valley metal is set where two slopes meet, and the panels lap over its edges.
Red Lion, OH
Flat coil goes into the roll-former and comes out as a full-length panel, so every panel is cut to fit the roof it goes on.
Farmers Retreat, IN
A dark metal-sided home gets a dark metal roof to match. Panels are staged on the ground, carried up, then set and fastened.
Reily Township, OH
Wall and gable panels are lined up plumb and fastened tight and flat, one after another, so the gable matches the roof.
Reily Township, OH
Each panel is set, lined up and fastened as the crew works across the slope. This is the stage where a new roof starts to look finished.
Fairview, IN
Snow guards keep snow and ice from sliding off a metal roof all at once onto gutters, cars and people below.
Piqua, OH
Vinyl siding comes off so the flashing can go behind it. Aluminum siding cannot, so we flash it in place.
Ridgeville, OH
A small curved roof with about a 54-inch radius, braces on each end, a doubled 2x4 beam and soffit nailers tied into the box beam, ready for metal.
Marysville, OH
A 40x88 pole barn before the metal ceiling: 2x6 purlins 3 feet on center, a flat 2x6 for the hanger brackets, and baffles so the insulation stays put.
Delaware County, OH
We peel the shingles back and check the boards, because we do not install over rotten or damaged decking. Only then do the underlayment and metal go on.
Delaware County, OH
Shingles come off onto tarps, debris goes straight into the dump trailer instead of the driveway, and the decking is checked before anything new goes down.
Delaware County, OH
The old chimney came out before the new metal roof. Ice-and-water shield goes around the opening and the metal goes on with one less place to leak.
Free estimates · Mon–Fri, 7 AM–5 PM
Free inspection and a written estimate. No pressure, and an honest answer on repair vs. replace.
(937) 423-9352Fill out our short form and we reply within one business day, usually sooner.
Mon–Fri, 7 AM–5 PM