Why modern metal roofs resist rust
Today’s steel roofing is built in layers. The steel gets a metallic coating, either zinc (galvanized) or a zinc-aluminum alloy such as Galvalume, then a primer and a paint finish baked on at the factory. Water has to get through all of that before it reaches bare steel.
The coating matters. Englert, a metal roofing manufacturer, says Galvalume outlasts galvanized steel by 10 to 25 years. Cleveland-Cliffs, which makes Galvalume steel, notes one trade-off: in the short term, galvanized can show less red rust at cut edges.
The steel in our standing seam and rib-panel roofs is always Galvalume-coated, with an SMP (silicone-modified polyester) paint finish in a range of colors.
Where does rust start on a metal roof?
- Scratches from foot traffic, dropped tools or grit under a boot.
- Cut edges at eaves, valleys and around pipes, where the coating ends.
- Exposed screws, especially once the washers fail and water sits around the head.
- Metal shavings left on a roof after drilling or cutting, which rust and stain the paint.
- Standing water and debris in valleys, behind chimneys and on low-slope sections.
- Incompatible metals touching, such as copper against steel.
Surface rust vs. rust-through
Surface rust is orange staining on top of a sound panel. Caught early, it can be cleaned, treated and coated, and the roof keeps going; see can you paint a metal roof? Rust-through is different. The steel itself has holes, usually along laps, edges and screws, and a coating over a hole does not make it a panel again.
The porch roof in the photo above, on a home in Lynn, Indiana, was well past the coating stage. The whole house was re-roofed in 26-gauge double lock standing seam, from the porch to the old flat roof on the back. See the Lynn job story.
How to keep a metal roof from rusting
- Stay off the roof, and keep ladders and grit off the panels.
- Clear leaves out of valleys and gutters so water does not sit.
- Replace backed-out or rusting screws on exposed-fastener roofs.
- Touch up deep scratches with the panel maker’s touch-up paint.
- Keep copper gutters, flashings and fittings away from steel panels.
- Have rust spots looked at early, while a treatment is still enough.
On our installs, all trims and flashings go on before the panels, so the crew is not walking back over finished metal. Fewer boots on the roof means fewer scratches for rust to start in.
Our take. Do metal roofs rust? A well-built modern one rarely rusts through, and small spots are an easy fix if you catch them. If you are seeing orange on your roof, call (937) 423-9352 and we will tell you whether it needs a treatment, a repair or a new roof.
Related questions
- Can You Paint a Metal Roof?
- How Long Does a Metal Roof Last?
- How Do You Fix a Leaking Metal Roof?
- How much does a metal roof cost in Ohio?
- All metal roof questions

